1.Composition of tool setter

TTC200 cable tool setter consists of a hardware and the software. The model of the software is SP-T10; the hardware also has a mounting base.

2.Technical Parameters
◆ The diameter of the touching pillar( for cutting tool touching): 12.7±0.005mm; the pillar’s hardness : HM8.5 ;
◆ Sensing direction of the pillar: ±X, ±Y, -Z;
◆ The trigger repeatability of the pillar(2σ): ≤ 2 μm;
◆ Input voltage is 24±10% V DC and output load current is 50 mA;
◆ Seal grade: IP68.

3.Technical Characteristics
◆As for the cable length, verify whether the cable length equipped is enough for installing the tool setter on your machine tool; If lengthening cable is
needed, special instructions should be given when ordering the product;
◆ If the square pillar of tool setter is needed, customers should give specialinstructions when ordering the products.
◆ Tool setter transmits signal through cable, reversal connecting tool setter’s power supply can reverse the state of the output signal;
◆ The position of tool setter pillar can be roughly and precisely adjusted by the connecting link of the pillar and the adjusting link of tool setter formounting.
◆ One LED indicator light is used to display the tool setter’s working state.